Inlet Cover and Outlet Cover of Silica Sand Dryer

Sunco Machinery Silica Sand Dryer Machine is ideal drying equipment in the market for drying all kinds of sand such as river sand, yellow sand , silica sand, frac sand, quartz sand, etc. After being dried, the sand moisture content can be reduced to be less than 3%, or even can be " Bone Dry" according to the customers' demand.

For one set of silica sand dryer machine, except the large drum/cylinder, the inlet conver and outlet cover are 2 important key parts for one successful sand drying system.

Feeding Inlet Cover of Sand Dryer Machine is one important parts of sand dryer. Feed Inlet Cover of sand dryer has two functions:

01. Wet sand goes into the silica sand dryer through the feeding inlet cover;

02. Feeding Inlet Cover keeps the high temperature air inside the rotary sand dryer, and avoid the hot air go out of the sand dryer cylinder. Thus, it make sure the high heat exchange efficiency between the wet sand and the high temperature air, and reduce the heat lose.

Discharging Outlet Cover of Silica Sand Dryer has the function as follows:

01. Keep the hot air inside the sand dryer;

02. To be connected with the air duct pipe, and the water vapour goes out through the air duct pipe which is on the top of the discharge cover.

03. On the bottom of the discharge cover of the sand dryer, there is one discharge hole. The dry sand goes out of the sand dryer from this discharge hole.

For detailed solution of silica sand drying system, you are welcome to visit and contact Sunco Machinery at your convenience.