Australia clients visit Sunco for Rotary Sand Dryer Machine

Australia clients visit Sunco Machinery for Rotary Sand Dryer Machine on September 20th, and the needed drying capacity is 20 tons per hour.

The requirement of Australia customers on silica sand dryer is as follows:

▲Raw Material: quartz sand 0,5-4 mm

▲Initial moisture content: 6%

▲Output Moisture Content: 0.5% 

▲Output Capacity: 20 tons per hour 

▲Fuel: Natural Gas

After talked face to face in detail, the Australia customers finally understand our design and solution, and prefered to the output capacity 20 tons per hour sand drying machine.

The work flow of sand drying plant is as follows:

▲ Natural Gas Burner is used to burn natural gas.

▲ Hot Air furnace supply the burning chamber for natural gas, and generate the high temperature air for the sand drying system.

▲ Tractor Shovel sends the wet sand into sand hopper with disc feeder.

▲ Sand hopper with disc feeder sends wet sand into inlet belt conveyor.

▲ Inlet belt conveyor sends wet sand into triple pass rotary sand dryer.

▲Triple pass sand rotary dryer not only supply the drying chamber, but also its help the hot air to heat and dry the sand sufficiently, and get rid of the water, and finally reduce the moisture content of the sand to the needed moisture content.

▲ Outlet belt conveyor takes out the dry sand from the dryer.

▲ Induced draft fan makes the hot air into the dryer, and makes the exhaust air out of the dryer.

▲ Some of the dust is mixed with the exhaust air, and inside the cyclone dust separator the dust is separated from the exhaust air. Finally the dust leave the cyclone dust separator through wind closing device, and the exhaust air leaves the cyclone dust separator, pass through the draft fan, and goes into water dedusting tower.

▲ Inside the water dedusting tower, the dust is collected by the water, and the exhaust air finally goes into atmosphere.

▲ Electric Control Panel is used to control the silica sand drying plant.